Table of Contents
Advertisement
Enclosure
Observe these guidelines when installing the switch in an enclosure:
Requirements
Warning
Switches should not be stacked on top of one another on a table or
desktop because that could present a personal safety hazard if you
need to move or replace switches.
Verify that the enclosure has adequate airflow so that unit does not
overheat.
Select an enclosure that is large enough for the switch and all other
included equipment.
The enclosure size must be determined by considering multiple
factors, including the outside ambient temperature, total heat
generated by the installed equipment, sealed or unsealed
enclosure type, enclosure material, paint color, mounting method
(wall, pole, ground, etc.), and sun exposure. The smaller enclosure
size you choose, the higher the risk of overheating the product
faces.
Note
If the product overheats in an enclosure that was selected without
taking into account these factors, the warranty of the product might
be voided. Consult Allied Telesis when assistance is needed.
The enclosure's BTU/hour rating must be higher than the total
BTU/hour values of installed equipment, over the expected
operating temperature range. For the operating temperature
ratings, refer to Table 19, "Environmental Specifications" on page
166.
Be sure to review the enclosure's installation guide for rules and
restrictions on site requirements, and to follow all guidelines and
safety warnings.
x330 Series Installation Guide for Virtual Chassis Stacking
E76
71
Advertisement
Table of Contents
