Gira 2100 Series Manual page 81

Continuous regulator / object regulator
Hide thumbs Also See for 2100 Series:
Table of Contents

Advertisement

Value change by long press NO
Time between two
telegrams
base
Time between two
telegrams
factor (3 ... 127)
Input X, disable
Disabling function
Only with disabling function enabled
Polarity of disable object
Behaviour at the beginning
of disable
Behaviour at the end of
disable
When channel 4 of the pushbutton interface is used as temperature limiter for the underfloor heating
Input 4
Limit temperature
(10 ... 60) * 1 °C
Hysteresis
07/17
Subject to change without notice
YES
130 ms
260 ms
520 ms
1 s
3 ... 127, 3
disabled
enabled
disable = 0 (enable = 1)
disable = 1 (enable = 0)
no reaction
reaction as with rising edge
reaction as with falling edge
transmission of current input
state
no reaction
reaction as with rising edge
reaction as with falling edge
transmission of current input
state
10 ... 60, 35
0.5 K
1 K
1.5 K
2 K
2.5 K
3 K
3.5 K
4 K
4.5 K
5 K
instabus KNX/EIB System
Sensor
Pressing the key for at least 5 s will cause the
current value to be cyclically reduced by the
fixed step width (50 lux) and to be transmitted.
After releasing the key, the previously
transmitted value remains stored.
This parameter defines whether a value
adjustment is possible.
Time between two telegrams when telegram
repetition is selected.
A new dimming telegram is transmitted
whenever this time elapses.
Only if "Value adjustment by long press" = "yes"
Channels used as binary inputs can be disabled
or enabled via an independent object.
Defines the value of the disable object at which
the input is disabled or enabled.
When the disabling function is used, the
reaction of the input can be defined separately
for the beginning and the end of disable.
If the temperature inside the floor exceeds this
value, the actuating variable of the heating
defined below will be set to "0" to prevent
excessive heat build-up in the floor.
If the temperature inside the floor drops below
the above limit value minus the hysteresis, the
actuating variable of the heating defined below
will be released again.
2100-xx/2101 xx Page 81/82

Advertisement

Table of Contents
loading

This manual is also suitable for:

2101 series

Table of Contents