Gira 2100 Series Manual page 29

Fig 2:
Comfort
Standby
Night
Frost/heat prot.
KONNEX switch-over object/
local operation/
operating mode after reset
Notes for operating mode switch-over via "switching" (2 x 1-byte):
• Any operating mode switch-over will also update the KONNEX switch-over object and can be, if applicable, read
out (set "read" flag!). If the "transmission" flag is set with this object, the current value will actively transmitted to
the bus following a change. After a return of bus voltage or an initialization, the value corresponding to the
adjusted operating mode will be actively transmitted on the bus if flag is set to "transmission". In case controller
extensions are used, the "transmission" flag must also be set!
• When parameterizing a presence key:
The presence object is active ("1") for the duration of an activated comfort mode extension.
The presence object will automatically be deleted ("0"), if the comfort mode extension is terminated after the
elapsed extension time, if the operating mode has been switched by a higher-priority control via the switch-over
objects or local operation or if a forced operating mode has been deactivated via the KONNEX forced-control
object (forced-control object  "00").
07/17
Subject to change without notice
Comfort
"01"
"02"
Presence detector object
"03"
"04"
Frost/heat protection
Frost/heat protection
1
0
1
Window status
object 34
(poss. delayed)
0
object 33
Comfort
Standby
Night
instabus KNX/EIB System
Sensor
deactivated "00"
"01"
"02"
"03"
"04"
KONNEX constraint object
2100-xx/2101 xx Page 29/82
Operat. mode