Gira 2100 Series Manual page 78

instabus KNX/EIB System
Sensor
Slat adjustment time base
Slat adjustment time factor
(3 ... 127)
Only if function = value transmitter
Function as
Only with dimming value transmitter
Transmit value on
Value on rising edge
Value on falling edge
Behaviour on return of bus
voltage
Value adjustment by long
press
Time between two
telegrams, base
Time between two
telegrams, factor (3 ... 127)
Step width (1 ... 10)
78/82 Page 2100-xx/2101 xx
130 ms
260 ms
...
34 s
3 ... 127, 20
dimming value transmitter
light-scene extension without
storage function
light-scene extension with
storage function
temperature value transmitter
brightness value transmitter
rising edge (key as make
contact)
falling edge (key as break
contact)
rising and falling edge (switch)
0 ... 255, 100
0 ... 255, 0
no reaction
reaction as with rising edge
reaction as with falling edge
transmission of current input
state
NO
YES
130 ms
260 ms
520 ms
1 s
3 ... 127, 3
1 ... 10, 10
Time during which a transmitted MOVE
telegram can be terminated by releasing the key
(STEP). This function is used for adjusting the
slats of a blind.
When used as value transmitter, the settings for
some applications are predefined.
Defines whether telegrams are to be transmitted
when a key is pressed and / or released
Defines the values transmitted after the above
type of actuation.
Defines whether and what kind of information
will be transmitted after return of bus voltage
Pressing the key for at least 5 s will cause the
current value to be cyclically reduced by the
parameterized step width and to be transmitted.
After release of the key, the previously
transmitted value remains stored.
This parameter defines whether a value
adjustment is possible.
Time between two telegrams when telegram
repetition is selected.
A new dimming telegram is transmitted
whenever this time elapses.
Only if "Value adjustment by long press" = "yes"
Step width by which the adjusted value is
changed on a long key-press.
07 /17
Subject to change without notice