Table of Contents
Advertisement
instabus KNX/EIB System
Sensor
47
PWM actuating
variable Additional
heating:
48
PWM actuating
variable Cooling:
48
PWM actuating
variable Basic cooling:
49
PWM actuating
variable Additional
cooling:
50
Setpoint temperature:
50
Setpoint temperature:
52
Feedback setpoint
shift:
53
Preset setpoint shift
57
Additional status
feedback
58
Actual temperature not
adjusted
12/82 Page 2100-xx/2101 xx
1-byte object with PWM actuating variable for status feedback of the
continuous actuating variable value for additional heating..
1-byte object with PWM actuating variable for status feedback of the
continuous actuating variable value for cooling operation
1-byte object with PWM actuating variable for status feedback of the
continuous actuating variable value for basic cooling operation
1-byte object with PWM actuating variable for status feedback of the
continuous actuating variable value for additional cooling operation
2-byte object for the output of the current temperature.
Depending on the control option, the possible range of values is
limited by the parameterized frost protection and/or heat protection
temperature.
2-byte object for receiving the current temperature setpoint of a
controller.
1-byte object for current setpoint shift feedback
x ≤ 0 ≤ y (0 = no active shifting); integers
The possible range of values (x to y) is fixed by the setting of the
upper and lower limits for the setpoint (parameterizable) in
combination with the step value (0.5 °C).
1-byte object for presetting a basic setpoint shift, e.g. via a controller
extension.
x ≤ 0 ≤ y (0 = no active shifting); integers
The possible range of values (x to y) is fixed by the setting of the
upper and lower limits for the setpoint (parameterizable) in
combination with the step value (0.5 °C).
In case the limits of the value range are exceeded by the preset
external value, the controller will automatically reset the received
value to the minimum and maximum limits.
1-byte object for general additional status feedback
2-byte object for the output of the actual temperature (room
temperature) as measured and not adjusted by the controller.
(possible range of values: -99.9 °C ... +99.9 °C /
Measuring range of internal temperature sensor:
0 °C to + 40 °C ±1 %)
07 /17
Subject to change without notice
Advertisement
Table of Contents
