Lenovo ThinkEdge SE350 V2 Hardware Maintenance Manual page 60

Important: To avoid damage to the drive connectors when removing or installing a hot-swap drive, make
sure that
– the node is securely placed within an enclosure; or that
– the top cover is in place and fully closed, when the node is not installed in an enclosure.
• Reinstall all the required drives and drive bay fillers into the drive cage (see
page 52).
• Proceed to complete the parts replacement (see
Demo video
https://www.youtube.com/watch?v=jb-2eoB6Zlk
Install a hot-swap drive
Follow instructions in this section to install a hot-swap drive into a drive bay.
About this task
Attention:
• Read "Installation Guidelines" on page 1
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node; then, remove it from the package and place it on a static-protective surface.
• To make sure that there is adequate system cooling, do not operate the server for more than two minutes
without either a drive or a drive bay filler installed in each bay.
• Locate the documentation that comes with the drive and follow those instructions in addition to the
instructions in this chapter.
• For a complete list of supported optional devices for the server, see
• The drive bays are numbered to indicate the installation order (starting from number "0"). Follow the
installation order.
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to https://datacentersupport.lenovo.com/products/servers/thinkedge/se350v2/7da9/downloads/driver-list
to see the latest firmware and driver updates for your server.
• Go to "Update the firmware" in User Guide or System Configuration Guide for more information on
firmware updating tools.
Note: Depending on the specific configuration, the drives, drive bay fillers, or drive cage might look different
from the illustrations in this section.
Important: To avoid damage to the drive connectors when removing or installing a hot-swap drive, make
sure that
• the node is securely placed within an enclosure; or that
• the top cover is in place and fully closed, when the node is not installed in an enclosure.
ThinkEdge SE350 V2 Hardware Maintenance Guide
52
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 2
"Install a hot-swap drive" on
to make sure that
https://serverproven.lenovo.com
125).
.