Lenovo ThinkEdge SE350 V2 Hardware Maintenance Manual page 59

Figure 44. Installation of the drive cage
Step 3. Tighten the four screws as illustrated.
Figure 45. Installation of the drive cage screws
After this task is completed
• Connect all necessary cables to the drive backplane(s) (see
page 129).
Attention: Before connecting the drive-backplane cables, make sure that the power input board module
and the power module board are installed in place.
• Install the top cover to the node (see
enclosure (see "Install a node to the rack" on page
"Cable routing for the hot-swap drives" on
"Install the top cover" on page
16).
124) or install the node into an
.
Chapter 1 Hardware replacement procedures
51