Figure 63. Installation of an M.2 heat sink to the M.2 tray
Step 4.
Install the M.2 drive with heat sink onto the I/O module board.
a.
Insert the M.2 drive at an angle to the connector.
b.
Lower down the other side of the M.2 drive; then, gently press the M.2 drive down into
place.
c.
Tighten the screw.
Figure 64. Installation of an M.2 boot drive
After this task is completed
• Install the drive cage and connect all the cables (see
• Proceed to complete the parts replacement (see
Demo video
https://www.youtube.com/watch?v=ewzFpHEFV7M
ThinkEdge SE350 V2 Hardware Maintenance Guide
72
"Install a drive cage" on page
"Complete the parts replacement" on page
50).
125).