I/O-Module-Board Connectors For Cable Routing - Lenovo ThinkEdge SE350 V2 Hardware Maintenance Manual

Figure 102. System-board connectors for cable routing
Table 2. System-board connectors for cable routing
Connector for the intrusion switch cable
1
SATA connector for Drive backplane 1 (lower)
2
MCIO connector 1 for Drive backplane 1 (lower)
3
MCIO connector 2 for Drive backplane 2 (upper)
4
Notes:
• For the installation or removal of the intrusion switch with cable, see
*
replacement" on page
• For the installation or removal of the lock position switch with cable, see
*
replacement" on page
• For the installation or removal of the fan cables, see
*

I/O-module-board connectors for cable routing

The following illustration shows the internal connectors on the I/O module board that are used for internal
cable routing.
ThinkEdge SE350 V2 Hardware Maintenance Guide
128
*
60.
64.
Connector for the lock position switch cable
5
Connector for the front operator assembly
6
Power connector for the I/O module board
7
Connectors for fan cables
8
"Intrusion switch with cable
"Keylock switch with cable
"Fan module replacement" on page
*
*
54.