Lenovo ThinkEdge SE350 V2 Hardware Maintenance Manual page 67

Install a front operator assembly
Follow instructions in this section to install a front operator assembly.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read "Installation Guidelines" on page 1
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
node; then, remove it from the package and place it on a static-protective surface.
Procedure
Step 1. Align the front operator assembly with the front and side edges of the node; then, place the front
operator assembly into its slot in the node.
Step 2. Tighten the three screws to secure the front operator assembly to the node.
Figure 50. Installation of the front operator assembly
After this task is completed
and "Safety inspection checklist" on page 2
Chapter 1
to make sure that
.
Hardware replacement procedures
59