Lenovo ThinkEdge SE350 V2 Hardware Maintenance Manual page 69

b. Tilt the intrusion switch and remove it from the node.
c. Disconnect the intrusion switch cable from the connector on the system board.
Figure 51. Removal of the intrusion switch with cable from the node
Step 3. (Optional) If necessary, remove the intrusion switch with cable from the intrusion switch holder.
a. Press the latches of the intrusion switch to release it from the holder.
b. Separate the intrusion switch with cable from the holder.
Figure 52. Separation of the intrusion switch from the holder
After this task is completed
• Install a replacement unit (see
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
Demo video
https://www.youtube.com/watch?v=HOfTO3W017E
"Install an intrusion switch with cable" on page 62).
.
Chapter 1 Hardware replacement procedures
61