Installing The Roll Bar - Toro Reelmaster 3100-D Operator's Manual

4. Check the slope indicator
steering tube of the machine.
Note:
when viewed from the operator's position.
5. If the slope indicator does not read 0°, loosen
the hardware securing the angle indicator to
the mounting bracket, adjust the indicator to
attain a 0° reading, and tighten the hardware.

Installing the Roll Bar

5
Parts Required
1
4
4
1
Operating the machine with a modified or damaged roll bar may not adequately
protect you in a rollover, which could result in death or serious injury.
• Do not install a damaged or modified roll bar on the machine.
• Replace a damaged roll bar; do not repair or alter it.
1. Lower the roll bar
mounting brackets
holes. Ensure that the vent tube
left side of the machine.
2. Secure each side of the roll bar to the
mounting brackets with 2 flange head bolts
and 2 locknuts. Torque the hardware to 81 N∙m
(60 ft-lb).
3. Secure the fuel-line-vent hose
Starting the engine with the fuel-line-vent hose disconnected from the vent tube will
cause fuel to flow from the hose, increasing the risk of fire or explosion. A fire or
explosion from fuel could result in death or serious injury.
Connect the fuel-line-vent hose to the vent tube before starting the engine.
Setup: Installing the Roll Bar
The slope indicator should read 0°
Roll-bar assembly
Flange-head bolt
Locknut
Hose clamp
onto the traction unit
, aligning the mounting
mounted on the
G402560
WARNING
is on the
G402561
to the vent tube with the hose clamp
CAUTION
Page 3–5
.
3466-297 A