9
Installing the Cutting Unit Drive Motors
1. Position the cutting units in front of the lift-arm-
pivot rods.
2. Remove the weight
mounting bolts
cutting unit.
3. Remove the plug from the bearing housing and
install the weight and O-ring.
4. Repeat steps
units.
5. Insert the O-ring
motor
6. Mount the motor to the drive end of the cutting
unit, and secure it with 2 bolts.
Adjusting the Lift Arms
10
Checking Lift Arm and Rear Cutting Unit Clearance
1. Start the engine, raise the cutting units, shut off
the engine, remove the key, and wait for all
moving parts to stop.
2. At the front cutting units, measure the distance
between the left lift arm
bracket
plate bracket.
Note:
16 to 5/16 inch)
this range, adjust the cutting unit lift cylinder.
3466-297A
, O-ring
from the end of the right
2
and
3
on the remaining cutting
on the flange of the drive
.
and the floor plate
, and the right lift arm and the floor
The correct clearance is 5 to 8 mm (3/
. If the clearance is not in
, and 2
G402582
G402583
G402584
Page 3–12
Setup: Installing the Cutting Unit Drive Motors