Cutting Unit Shift Lever
Raise/Lower
Side Shift
Model 03171
Note:
Sideshift the cutting units only when they are raised or if they are on the ground and
the machine is moving.
Shifting the cutting units downhill decreases machine stability. This could cause a
rollover, which may result in personal injury or death.
Shift the cutting units uphill while on a side hill.
Slope Indicator
The slope indicator indicates the side hill angle of the machine in degrees.
3466-297A
G465011
G465022
DANGER
Page 4–3
Lower
Note:
The cutting units do not lower
unless the engine is running. You do not
need to hold the lever in the forward
position while the cutting units are
lowered.
Raise
Note:
The reels do not run while the
cutting units are raised.
Shift right
Shift left
Product Overview: Controls