Chapter 7: Storage; Storing The Machine; Storing The Battery - Toro Reelmaster 3100-D Operator's Manual

Storing the Machine

1. Park the machine on a level surface, lower the cutting units, engage the parking brake,
shut off the engine, and remove the key.
2. Thoroughly clean the traction unit, cutting units, and the engine.
3. Check the tire pressure.
4. Check all fasteners for looseness; tighten them as necessary.
5. Grease or oil all grease fittings and pivot points. Wipe up any excess lubricant.
6. Lightly sand and use touch-up paint on painted areas that are scratched, chipped, or
rusted. Repair any dents in the metal body.
7. Service the battery and cables as follows:
A. Remove the battery terminals from the battery posts.
B. Clean the battery, terminals, and posts with a wire brush and baking-soda solution.
C. Coat the cable terminals and battery posts with Grafo 112X skin-over grease (Toro
Part No. 505-47) or petroleum jelly to prevent corrosion.
D. Slowly charge the battery every 60 days for 24 hours to prevent lead sulfation of the
battery.
8. Prepare the engine as follows:
A. Drain the engine oil from the oil pan and install the drain plug.
B. Remove and discard the oil filter. Install a new oil filter.
C. Fill the engine with specified motor oil.
D. Start the engine and run it at idle speed for approximately 2 minutes.
E. Shut off the engine and remove the key.
F. Flush the fuel tank with fresh, clean fuel.
G. Secure all the fuel-system fittings.
H. Thoroughly clean and service the air-cleaner assembly.
I. Seal the air-cleaner inlet and the exhaust outlet with weatherproof tape.
J. Check the antifreeze protection and add a 50/50 solution of water and ethylene
glycol antifreeze as needed for the expected minimum temperature in your area.

Storing the Battery

If you are storing the machine for more than 30 days, remove the battery and charge it fully.
Either store it on the shelf or on the machine. Leave the cables disconnected if they are
stored on the machine. Store the battery in a cool atmosphere to avoid quick deterioration of
Storage Page 7–1
Chapter 7
Storage
3466-297 A