Servicing the Fuses
1. Prepare the machine for maintenance.
2. Lift the cover from the control arm.
Right side of the machine
Control-arm cover
3. Locate the open fuse in the fuse holder or fuse block.
4. Replace the fuse with the same type and amperage fuse.
5. Assemble the cover onto the control arm.
Drive System Maintenance
Checking the Tire Pressure
Low tire pressure decreases machine side hill stability. This could cause a rollover,
which could result in death or serious injury.
Do not under-inflate the tires.
Note:
Maintain the recommended pressure in all tires to ensure a good quality of cut and
proper machine performance.
1. Measure the air pressure in each tire. The correct air pressure in the tires is 97 to 110
kPa (14 to 16 psi).
2. If needed, add air to of remove air from the tires until you measure 97 to 110 kPa (14 to
16 psi).
Maintenance: Electrical System Maintenance
G416222
Fuse holder
Fuse block
WARNING
Page 6–22
3466-297 A