Installing The Roll Bar; Installing The Seat; Installing The Service And Clip Decals - Toro Greensmaster TriFlex 3400 Operator's Manual

Description
Declaration of Conformity
Noise rating certificate
Ignition keys
1

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar
4 Bolt (1/2 x 3-3/4 inches)
4 Flange nut (1/2 inch)
Procedure
1. Remove the top crate support from the crate.
2. Remove the roll bar from the crate.
3. Use 4 bolts (1/2 x 3-3/4 inches) and 4 flange
nuts (1/2 inch) to install the roll bar into the
ROPS brackets on each side of the machine as
shown in Figure
1. Roll bar
2. Bolt (1/2 x 3-3/4 inches)
4. Torque the fasteners to 136 to 149 N∙m (100 to
110 ft-lb).
3.
Figure 3
3. ROPS bracket
4. Flange nut (1/2 inch)
Qty.
1
For CE compliance.
1
2 Start the engine.
2

Installing the Seat

Parts needed for this procedure:
Seat Kit (order separately; contact your authorized
1
Toro distributor)
Procedure
Acquire your desired seat kit from your distributor and
install it to the machine; refer to the kit Installation
Instructions.
3
Installing the Service and
Clip Decals
Parts needed for this procedure:
1 Service decal (Part No. 139-2728)
1 Clip decal (115-8156)
Procedure
Install the service decal (Part No. 139-2728) and the
clip decal (Part No. 115-8156) to the seat; refer to
Figure 4 for the premium seat (Model No. 04719) or
Figure 5 for the standard seat (Model No. 04508).
g233739
10
Use