1. Hood latch
7.
Screw the bolt into the other arm of hood-lock
bracket to lock the latch in position
Note:
Tighten the bolt securely but do not
tighten the nut.
1. Bolt
2. Nut
7
Installing the Exhaust
Guard (CE Only)
Parts needed for this procedure:
1
Exhaust guard
4
Self-tapping screw
Procedure
1.
Position the exhaust guard around the muffler
while aligning the mounting holes with the holes
in the frame
(Figure
Figure 9
(Figure
Figure 10
3. Arm of hood-lock bracket
11).
g012630
10).
1. Exhaust guard
2.
Secure the exhaust guard to the frame with 4
self-tapping screws
8
g012631
Installing the Roll Bar
Parts needed for this procedure:
1
Roll-bar assembly
4
Flange-head bolts
4
Locknuts
1
Hose clamp
Procedure
Important:
protection system (ROPS). Replace a damaged
ROPS; do not repair or revise it.
1.
Lower the roll bar onto the traction unit mounting
brackets, aligning the mounting holes. Ensure
that the vent tube on the roll bar is on the left
side of the machine
16
Figure 11
(Figure
11).
Never weld or modify a rollover
(Figure
12).
g008875