Assembling The Cutting Unit And Rear Carrier Frame - Toro Reelmaster 3100-D Operator's Manual

Assembling the Carrier Frames for the Front Cutting
Units (continued)
1. Align the holes in the plates of the front-carrier
frame with the holes in the cutting unit
mounting plates.
Note:
of the cutting unit, use the middle holes of each
plate.
2. Assemble the cutting unit to the carrier frame
as shown.
3. Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
4. Repeat this procedure for the other front
cutting unit and carrier frame.

Assembling the Cutting Unit and Rear Carrier Frame

Cutting Unit with Mounting Plates
Note:
The rear carrier frame is part of the optional lift arm kit.
1. Align the holes in the plates of the rear-carrier
frame with the holes in the cutting unit
mounting plates.
Note:
of the cutting unit, use the middle holes of each
plate.
2. Assemble the cutting unit to the carrier frame
as shown.
3. Torque the flange locknuts to 37 to 45 N∙m (27
to 33 ft-lb).
3466-297A
If you are starting assembly at the back
If you are starting assembly at the back
G402577
G402578
Page 3–10 Setup: Installing the Carrier Frames to the Cutting Units