Preparing The Machine - Toro Reelmaster 3100-D Operator's Manual

Adjusting the Rear Cutting Unit Clearance (continued)
2. Grasp the cylinder rod close to the jam nut with
a pliers and rag, and rotate the rod.
Note:
and bumper stop clearance.
3. Start the engine, raise the cutting units, shut off
the engine, remove the key, and wait for all
moving parts to stop.
4. Measure the clearance between the wear strap on the top of the rear cutting unit wear
bar and the bumper stop.
Note:
5. Repeat steps
6. Start the engine, lower the cutting units, shut off the engine, remove the key, and wait for
all moving parts to stop.
7. Tighten the jam nut.

Preparing the Machine

11
1. Park the machine on a level surface, lower the cutting units, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait for all moving parts to stop.
3. Check the tire air pressure and adjust if needed.
Note:
4. Check the hydraulic-fluid level.
5. Grease the machine.
Note:
parts.
6. Open the hood and check the coolant level.
7. Check the level of the engine-oil level, and close and latch the hood.
Note:
and after the engine is first started.
Setup: Preparing the Machine
Shortening the rod reduces wear strap
The correct clearance is 0.51 to 2.54 mm (0.02 to 0.10 inch).
1 through 4 as needed.
The tires are overinflated for shipping.
Failure to properly grease the machine will result in premature failure of critical
The engine ships with oil in the crankcase; however, check the oil level before
G402589
Page 3–15 3466-297 A