Installing The Roll Bar; Installing The Front Lift Arms - Toro Reelmaster 3100-D Operator's Manual

5

Installing the Roll Bar

Parts needed for this procedure:
1 Roll-bar assembly
4 Flange-head bolt
4 Locknut
1 Hose clamp
Procedure
Important:
Never weld or modify a rollover
protection system (ROPS). Replace a damaged
ROPS; do not repair or revise it.
1. Lower the roll bar onto the traction unit mounting
brackets, aligning the mounting holes. Ensure
that the vent tube on the roll bar is on the left
side of the machine
1. Roll bar
2. Mounting bracket
3. Vent tube
2. Secure each side of the roll bar to the mounting
brackets with 2 flange head bolts and 2 locknuts
(Figure 8). Torque the fasteners to 81 N∙m (60
ft-lb).
3. Secure the fuel line vent hose to the vent tube
on the roll bar with the hose clamp.
(Figure 8).
Figure 8
4. Fuel line vent tube hose
5. Hose clamp
CAUTION
Starting the engine with the fuel line vent
hose disconnected from the vent tube
will cause fuel to flow from the hose,
increasing the risk of fire or explosion.
A fire or explosion from fuel can burn
you and others and can cause property
damage.
Connect the fuel line vent hose to the
vent tube prior to starting the engine.
6
Installing the Front Lift
Arms
Parts needed for this procedure:
1 Lift arm kit (optional kit—order separately)
Preparing to Install the Lift Arms
1. Insert a pivot rod into each lift arm and align the
mounting holes
g011160
1. Lift arm
2. Secure the pivot rods to the lift arms with 2 bolts
(5/16 x 7/8 inch).
3. Torque the bolts to 37 to 45 N∙m (27 to 33 ft-lb).
4. At the front of the machine, remove the 2 flange
capscrews (1/2 x 2 inches) that secure the
pivot-shaft link to the lift arm pivot shafts, and
remove the link
Note:
Retain the pivot shaft link and capscrews.
16
(Figure 9).
Figure 9
2. Pivot rod
(Figure 10).
g011162