Setup; Installing The Roll Bar - Toro Greensmaster eTriFlex 3360 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
1

Installing the Roll Bar

Parts needed for this procedure:
1 Roll bar assembly
8 Hex-head bolt (3/8 x 1-1/2 inch)
8 Nut (3/8 inch)
Procedure
1. Remove the top support from the crate.
2. Remove the roll bar from the crate.
Description
Roll bar assembly
Hex-head bolt (3/8 x 1-1/2 inch)
Nut (3/8 inch)
Seat Kit (order separately; contact your
authorized Toro distributor)
Service decal (Part No. 137-8132)
Steering wheel
Cap
Washer
Locknut
Screw (M5)
Nut (M5)
Grass-basket hook
Flange bolts
Cutting unit (order separately; contact
your authorized Toro distributor)
Grass basket
Electric counterweight
Capscrew
O-ring
No parts required
Production year decal
CE warning decal (Part No. 139-8321)
CE mark decal (Part No. 93-7252)
No parts required
Qty.
1
8 Install the roll bar.
8
1 Install the seat.
1 Install the service decal.
1
1
Install the steering wheel.
1
1
2
Connect the 12 V battery.
2
6
Install the grass-basket hooks.
12
3
3
Install the cutting units.
3
6
3
–
Adjust the machine settings.
1
1 Install the CE decals (if required).
1
–
Reduce the tire pressure.
3. Use 8 hex-head bolts (3/8 x 1-1/2 inch) and
8 nuts (3/8 inch) to secure the roll bar to the
roll-bar brackets on each side of the machine
(Figure 3).
Note:
Have an assistant help you to position
and secure the roll bar to the machine.
7
Use