Error Messages - Agilent Technologies E4418B User Manual

Error Messages

Error Messages
Error Messages
-101
Invalid character
An invalid character was found in the command string. You may have inserted a
character such as #, $, or % in the command header or within a parameter.
For example, LIM:LOW O#.
-102
Syntax error
Invalid syntax was found in the command string.
For example, LIM:CLE:AUTO, 1 or LIM:CLE: AUTO 1.
-103
Invalid separator
An invalid separator was found in the command string. You may have used a
comma instead of a colon, semicolon, or blank space; or you may have used a
blank space instead of a comma.
For example, OUTP:ROSC,1.
-105
GET not allowed
A Group Execute Trigger (GET) is not allowed within a command string.
-108
Parameter not allowed
More parameters were received than expected for the command. You may have
entered an extra parameter, or added a parameter to a command that does not
accept a parameter.
For example, CAL 10.
-109
Missing parameter
Fewer parameters were received than expected for the command. You omitted one
or more parameters that are required for this command. For example,
AVER:COUN.
-112
Program mnemonic too long
A command header was received which contained more than the maximum 12
characters allowed.
For example, SENSeAVERageCOUNt 8.
-113
Undefined header
A command was received that is not valid for this power meter. You may have
misspelled the command, it may not be a valid command or you may have the
wrong interface selected. If you are using the short form of the command,
remember that it may contain up to four letters.
For example, TRIG:SOUR IMM.
4-4 Agilent E4418B User's Guide