Agilent Technologies E4418B User Manual page 167

-221
Settings conflict
This command occurs under a variety of conflicting conditions. The following list
gives a few examples of where this error may occur:
•If the READ? parameters do not match the current settings.
•If you are in fast mode and attempting to switch on for example, averaging, duty
•Trying to clear a sensor calibration table when none is selected.
-221
Settings conflict;DTR/DSR not available on RS422
DTR/DSR is only available on the RS232 interface.
-222
Data out of range
A numeric parameter value is outside the valid range for the command. For
example, SENS:FREQ 2KHZ.
-224
Illegal parameter value
A discrete parameter was received which was not a valid choice for the command.
You may have used an invalid parameter choice.
For example, TRIG:SOUR EXT.
-226
Lists not same length
This occurs when SENSe:CORRection:CSET[1]|CSET2:STATe is set to
ON and the frequency and calibration/offset lists do not correspond in length.
-230
Data corrupt or stale
This occurs when a FETC? is attempted and either a reset has been received or the
power meter state has changed such that the current measurement is invalidated
(for example, a change of frequency setting or triggering conditions).
-230
Data corrupt or stale;Please zero and calibrate Channel A
When CAL[1|2]:RCAL is set to ON and the sensor currently connected to
channel A has not been zeroed and calibrated, then any command which would
normally return a measurement result (for example FETC?, READ?, or MEAS?)
will generate this error message.
-230
Data corrupt or stale;Please zero Channel A
When CAL[1|2]:RCAL is set to ON and the sensor currently connected to
channel A has not been zeroed, then any command which would normally return a
measurement result (for example FETC?, READ?, or MEAS?) will generate this
error message.
Agilent E4418B User's Guide
cycle or limits.
Error Messages
Error Messages
4-7