Agilent Technologies E4418B User Manual page 141

System
Inputs
The softkey menu structured to this hardkey affects the system setup and the channel
setup.
Press this hardkey to access the "System/Inputs" menu. This menu allows you to set
up a variety of conditions for your power meter, for example: GP-IB address, serial
interface parameters, sensor calibration tables, averaging, duty cycle, range, offset,
service. It also allows you to review errors.
•
Remote Interface
Press this softkey to access a menu which allows you to select and configure
the remote interface, select the command set you want to use, or obtain an
interface overview
Command Set
n
Press this softkey to access a menu which allows you to select the
remote programming language you want to use. Refer to "Programming
Language Selection", on page 2-57 for further information.
SCPI
u
Press this softkey to select SCPI (Standard Commands for
Programmable Instruments) as the remote programming language you
want to use.
HP 437B
u
Press this softkey to select the Agilent 437B emulation mode. In this
mode the power meter responds to the Agilent 437B programming
command set.
Select Interface
n
Press this softkey to access a menu which allows you to select between
GP-IB, RS232 and RS422 as the remote interfaace standard.
GP-IB
u
Press this softkey to select the GP-IB port for remote operation.
RS232
u
Press this softkey to select the serial port for remote operation using
the RS232 Standard.
RS422
u
Press this softkey to select the serial port for remote operation using
the RS422 Standard.
Configure Interface
n
Agilent E4418B User's Guide
Front Panel Menu Reference "System/Inputs" Menu
Menu Reference
3-19