Bender COMTRAXX CP305 Manual page 35

Date and time
Setting option for
• Time, date, time zone, daylight saving time
• Synchronisation with time server (SNTP) (auto DHCP, on, off)
Display
General
• Language
• Alignment
• Cleaning mode active
Setting option: deactivated or locked for 5...20 s
Alarm messages
• Set the time until the page is changed for several pending alarms.
Setting range: 3/5/10 seconds
Standby mode
• Timeout (display) after 1...10 minutes
• Standby mode (automatic dimming, off, display time)
• Brightness "off", 10...90%
In the event of an alarm, the display is always at 100% brightness. Only after the alarm has been
eliminated does the CP305 go into standard operation with the configured standby mode.
The display only shows most of the settings. You can make some settings as soon as the administrator has
logged into the device with a PIN (factory setting 8070). The complete configuration takes place in the web
browser.
Security
Display
• PIN (enabled/diabled)
• Change PIN
The display PIN for logging on to the device always consists of 4 digits.
The factory setting for the PIN is 8070.
If you forget the PIN, you can reset it in the web user interface.
COMTRAXX® CP305 - Control Panel
CP305_D00425_02_M_XXEN/07.2023 35