Bender COMTRAXX CP305 Manual page 26

Commissioning
If no test or alarm addresses have been set up, you will receive a message to this effect. You can use the
web user interface to configure these addresses.
You can configure additional settings on the display or the web user interface on the PC.
NFC (near-field communication)
The powered device can also have its parameters set via NFC. The interface is activated on the CP305 under
> Settings > Interface > NFC. Afterwards, the prepared configuration can be loaded onto the device using the
Bender Connect app.
Electromagnetic disturbances may affect the NFC dialog between the CP305 and an external NFC transceiver.
26 CP305_D00425_02_M_XXEN/07.2023
The NFC interface can be used to transmit a previously configured device parameter
setting directly to the device.
This function is available only via the Bender Connect App. You can find this app in
the Appstores for iOS and Android.
In the Bender Connect app the device first needs to be made known. Then the device-
specific setting options are shown so that they can be configured. When the data is
transferred, feedback is given whether the parameter configuration has been successful.
Parameter settings can be transmitted to the device via the Bender Connect app by
holding the mobile phone close to the device.
To a de-energised device, a parameter setting can be transferred via the Bender
Connect app. This setting is then activated automatically when the device is connected
to the current supply.
When a device is plugged in, too, parameters can be configured via the Bender Connect
App. To this end, the NFC interface first needs to be activated in the device.