Drive Controller-Specific Properties; Drive Controller-Specific Hardware Properties; Drive Controller-Specific Properties Of The Cpu - Siemens SIMATIC S7-1500 System Manual

Application planning

6.3 Drive Controller-specific properties

Software requirements
Table 6- 2
Configuration in the TIA Portal
Integrated SIMATIC S7-1500 CPU
SINAMICS Integrated
Information on the hardware and functions supported by SINAMICS Startdrive can be found
at (https://support.industry.siemens.com/cs/ww/en/view/109761180)
Note
Licensing
The S7 controller and SINAMICS Integrated are licensed in the TIA Portal via STEP 7
Professional or Startdrive.
6.3 Drive Controller-specific properties
6.3.1

Drive Controller-specific hardware properties

The SIMATIC Drive Controller is part of the SINAMICS S120 drive system and the same
installation conditions and installation rules as for SINAMICS S120 therefore apply.
The assembly conditions and assembly rules are available in the SINAMICS S120 manuals and
in the EMC Installation Guideline
(https://support.industry.siemens.com/cs/ww/en/view/60612658).
6.3.2

Drive Controller-specific properties of the CPU

The SIMATIC Drive Controller is optimized for automation solutions with Motion Control in
which SINAMICS S120 high-performance converters are used.
With its extensive field bus interfaces, the SIMATIC Drive Controller is ideal for modular
machine concepts.
104
Software requirements
Requirement
SIMATIC STEP 7 Professional V16 or higher
For programming the safety program of the F-CPU
"STEP 7 Safety Advanced" from V16 onwards
SINAMICS Startdrive Basic or Startdrive Advanced, V16
or higher
Startdrive Advanced has additional engineering func-
tions compared to Startdrive Basic such as a safety
acceptance test.
Note: It is not possible to configure SINAMICS Integrat-
ed with the STARTER configuration tool.
System Manual, 11/2023, A5E46600094-AD
SIMATIC Drive Controller