Attaching The Access Point To The Mounting Bracket - Allied Telesis TQ6000 GEN2 Installation Manual

Attaching the Access Point to the Mounting Bracket

To attach the wireless access point on the mounting bracket on the wall or
ceiling, perform the following procedure:
1. Align the bottom of the access point over the bracket so that the two
screws on the bottom of the device fit into the bracket keyholes. Refer
to Figure 25. (These are the two access point chassis screws installed
in "Pre-fitting the Mounting Bracket on the Access Point" on page 44.)
Figure 25. Installing the Access Point on the Mounting Bracket
2. Slide the access point forward until its screws are seated in the bracket
keyhole slots and the bracket thumbscrew is aligned with the screw
hole on the front panel.
See Figure 26 on page 54 for the access point and bracket
orientations.
TQ6000 GEN2 Access Points Installation Guide
53