Desktop Installation - Mitel MiVoice Office 400 System Manual

Installation
5. Connect the earthing (see
6. Fit the housing cover.
7.
Secure the cage nuts in the appropriate positions in the rack's fastening rails (see
page 91).
8. Secure the communication server to the rack's fastening rails using the M6 screws, the plastic washers
and the cage nuts.
9. Fasten the snap-on tag to the front panel.
10. Reconnect the communication server to the power supply.
4.2.6.2 Installing the cable cover
Materials required:
• Cable cover set
• Screwdriver
To install the cable cover proceed as follows:
1. Pull off the screw covers on the left and right of the front panel.
2. Use the M4 screws of the cable cover set to secure the brackets for the cable cover to the
communication server.
Note:
The two brackets are not identical. Compare the cable brackets with the ones in
brackets for the cable
3. Fit the cable cover over the brackets from above until they are felt to engage.
4.2.7

Desktop installation

To protect the cable connections the communication server can also be secured using three screws. The
same drilling plan (see
(see Wall-mounting
93
Connecting the earthing
cover.
Figure 14: Installing the brackets for the cable cover
Drilling plan on page 88) and the same procedure apply as for wall mounting
procedure).
wire).
System Manual for Mitel SMB Controller
Rack-mounting on
Installing the
Release 7.1