Installation
4.5
Equipping the Basic System
For an individual expansion the basic system can be equipped with interface cards, the appropriate wiring
adapters and system modules. An overview can be found in the Chapter
Capacity.
4.5.1
Fitting an interface card
Interface cards are fitted to slots IC1...IC4 (see
front
panel).
CAUTION:
Be sure to observe the
1.
Shut down the communication server (see
2.
Remove the housing cover.
3.
Place the interface card at a slight angle into the required slot (see
the angled side of the interface card is facing backwards (i.e. it must not project over the wiring adapter
slots).
4.
Carefully press the interface card downwards until the two lateral metal clamps engage.
5.
Fit the corresponding wiring adapter (see
wiring adapter slot WA1...WA4.
6.
Fit the housing cover.
7.
Reconnect the communication server to the power supply.
4.5.2
Fitting a wiring adapter
Wiring adapters are used to route the interfaces of the interface cards to the RJ45 sockets on the front
panel and are fitted to slots WA1...WA4. (see also
99
Mainboard interfaces, display and control elements and
Safety
regulations.
Shut-down
Fitting a wiring adapter
Figure 19: Fitting an interface card
Interfaces, display and control elements
Expansion Stages and System
mode) and disconnect it from the power supply.
Fitting an interface
on page 99) into the appropriate
System Manual for Mitel SMB Controller
card). Make sure
on page 40).
Release 7.1