Function Code For Remote Maintenance Access - Mitel MiVoice Office 400 System Manual

Configuration
Note:
It is advisable not to keep the remote maintenance access permanently activated. This ensures
that the communication server data cannot be manipulated from a remote location by unauthorized
persons.
5.6.2

Function code for remote maintenance access

Table 79: Function code for remote maintenance access
Enable/bar a one-off remote maintenance access
Enable/bar a permanent maintenance access
When remote maintenance access is enabled using function code *754, access will automatically be
barred again once the remote maintenance process has been completed. It is possible to bar remote
maintenance manually using #754 before it is initiated.
Remote maintenance access can be enabled permanently using the function code *753. To bar access, the
authorized user must enter the function code #753 manually.
The enabling or barring of remote maintenance access using the function code is signalled in each case by
an acknowledgement tone.
Remote maintenance access can also be enabled or barred in WebAdmin, if the relevant authorization has
been given.
Note:
In a QSIG network it is important to ensure that the authorization to change the remote maintenance
access is also denied to unauthorized PISN users. Otherwise, a PISN user would be able to use an
abbreviated dialling number defined for the destination PINX and containing the appropriate function
code to change the remote maintenance access to the destination PINX.
Mitel Advanced Intelligent Network:
In an AIN the remote maintenance access of all the nodes depends on the setting in the Master. If remote
maintenance access is enabled in the Master, both the AIN configuration and the offline configuration of
the satellites are enabled.
185
*754 / #754
*753 / #753
System Manual for Mitel SMB Controller
Release 7.1