Analogue Phones Mitel 6710 Analogue, Mitel 6730 Analogue - Mitel MiVoice Office 400 System Manual

If an SB-8 / SB-8ANT is operated on two DSI interfaces, it is recommended always to use two
neighbouring ports.
Mitel Advanced Intelligent Network:
As the DECT systems of the individual nodes in an AIN do not run synchronously, the two DSI interfaces of
an SB-8 / SB-8ANT must always be connected to the same node.
Table 74: Operating state display on Mitel DECT radio units
LED flashing (two LEDs on the SB-8)
green
red / green
orange
red
not flashing and not lit
For further display variants, see
4.8.7 Analogue phones Mitel 6710 Analogue, Mitel 6730
Analogue
The phones can be used as desktop model or as wall model.
Connecting the phone
1. Stick the connector on the longer, straight end of the handset cord on the underside of the phone into
the socket with the handset symbol until it snaps into place. Feed the cable through the strain relief and
connect the other end to the handset.
2. Feed the small connector of the phone connection cable on the rear side of the phone into the socket
until it snaps into place. Stick the connector on the other end into the phone cord.
Preparing the phone for message waiting indication (MWI)
Release 7.1
System Manual for Mitel SMB Controller
6 Local power supply
+
Information
Operating state
Startup procedure running
Transmission of DECT sequences
Fault
LED switched off or radio unit defective or not in operation
Operating state of the Mitel DECT radio
Local power supply Local power supply
+ +
units.
Installation
170