Installing The Power Distribution Board - Dell PowerEdge R930 Owner's Manual

Figure 84. Removing the power distribution board
1 screw (3)
3 left PSU bay
Next steps
1 Install the PDB.
2 Install the following:
a Expansion card risers, if installed
b Storage controller card
c AC power supply unit (PSU) or PSU blank, if installed
d PSU bay
3 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Removing the left or right expansion card riser
Removing the integrated storage controller card
Removing an AC power supply unit
Removing the power supply unit blank
Removing the power supply unit bay

Installing the power distribution board

After working inside your system
Installing the power distribution board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1 Follow the safety guidelines listed in the Safety instructions section.
152 Installing and removing system components
2 PDB
4 right PSU bay