Installing A Power Distribution Board; Cable Routing For Power Distribution Board - Dell PowerEdge C6320 Owner's Manual

Installing a power distribution board

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: If removed, you must replace the power distribution board 2 and the power
distribution board-connector before replacing the power distribution board 1.
1. If removed, first place the power distribution board 2 in the system. Otherwise skip to step 5.
NOTE: To install the power distribution board 2 below the power distribution board 1, angle the
board during installation.
2. Replace the screws securing the power distribution board 2 to the system.
3. Replace the power distribution board-connector.
4. Connect all the cables to the power distribution board 2.
You must route these cables properly through the tabs on the chassis to prevent them from being
pinched or crimped.
5. Replace the power distribution board 1 to the system.
6. Replace the screws securing the power distribution board 1 to the system.
7. Connect all the cables to the power distribution board 1.
You must route these cables properly through the tabs on the chassis to prevent them from being
pinched or crimped.
8. Replace the power supply unit.
9. Close the system.
10. Reconnect the system to its electrical outlet and turn on the system, including any attached
peripherals.
Related Information
Installing a power supply unit
Closing the system

Cable routing for power distribution board

The following figures shows an example using a 1U node system.
97