Projector Led Shutter Indicators; Turning Off The Projector - Christie Griffyn 4K32-RGB Installation And Setup Manual

LED State
Flashing
Yellow Solid
Flashing yellow/green
Flashing
Flashing yellow/blue
Red Solid
Flashing
Off

Projector LED shutter indicators

Identify the shutter LED state colors and meaning.
LED
Solid magenta
Off

Turning off the projector

When powering off in preparation for inspection or maintenance, always disconnect from AC.
1. To turn the light source off using the projector keypad, press and hold the
hear a beep.
To turn off the light source using the remote, press and hold the OFF button until you hear a
beep.
When powering off the projector, allow the projector to complete its cool down cycle. Do not
immediately unplug the projector if this can be avoided.
2. To turn off power to the projector, turn off the projector breaker switch.
3. Depress the red tab on the side of the plug and disconnect from AC power.
Griffyn 4K32-RGB Installation and Setup Guide
020-103314-05 Rev. 1 (04-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Startup
Warning in
standby
Warning during
startup
Warning with
light source on
Warning during
cool down
Error in
standby
Error
AC off
State
Shutter closed
Shutter open
Description
Projector is moving to light source on state. Light
source is warming up. Video electronics are
initializing.
Projector is in standby state. A problem exists with
the projector that does not prevent it from
operating.
Projector is in a startup state. A problem exists
with the projector that does not prevent it from
operating.
Light source is on. A problem exists with the
projector that will not cause it to shut down.
Projector is in a cool down state. Light source is off.
Video electronics and light source are cooling
down. A problem exists with the projector that
does not prevent it from operating.
Projector is in standby. An error exists that
prevents the projector from starting up.
An error with the projector exists during startup,
cool down, or when the light source is off. Projector
will proceed to shut down.
The AC power is off.
Description
The shutter is closed.
In standby, the shutter is always automatically closed and
the magenta light is muted.
The shutter is open.
Installation and setup
button until you
23