Automatic Mode; Set Function - HP 333A Operating And Service Manual

n.
p.
DO NOT EXCEED MAXIMUM INPUT
я ) it З 4
Observe
distortion either in percentage
or
VOLTAGES
LISTED ON REAR PANEL.
dB, as indicated by meter deflection and
METER RANGE switch setting. For example,
c. Connect input signalto R. Е. INPUT terminal
on rear panel.
ACRI should be checked. А
spare diode is located on the
outside of the A4 shield.
of the rejection curve.
If desired, rms voltage of input signal can
VOLTMETER, and setting METER RANGE
3-20. AUTOMATIC MODE.
Ce
d.
| Et (
Perform steps athroughlof Paragraph 3-19.
b.
Set NORM.-R. F. DET.
switch to NORM,
i та
Adjust frequency dial vernier and BALANCE
c. Set FUNCTION
switch to VOLTMETER.
When meter indication is less than 10% of
manually nulled below 10% of SET LEVEL
obtain on-scale meter indication.
g.
The dB scale of the 333A/334A is calibrated
3-3