Mitsubishi Electric MELDAS C6 Parameter Manual page 50

# Items
aux03 Time
(bit7) constant
setting
changeover
for software
acceleration/
deceleration
5. Base Specifications Parameters
Details
0: Accelerating time is G0tL(G1tL).
If the time is set to the software
acceleration/deceleration 2nd step time constant
(#2005 G0t1) under such condition as the
acceleration/deceleration before G00 interpolation
and the software acceleration/deceleration are
used one together, the inclination at software
acceleration/deceleration will be steeper.
Thus, the acceleration for G28/G30 will be larger
than that for G00.
Speed
G0tL－G0tl
G0tL
Acceleration
G0tl G0tl
1. Total accelerating time is "G0L".
2. The time for curve part is "G0t1".
3. The time for linear part is obtained by
"G0tL-(2 G0t1)".
(Continued on the next page)
44
Get other manuals https://www.bkmanuals.com
Setting range (unit)
0/1
t
t