Control Parameters - Mitsubishi Electric MELDAS C6 Parameter Manual

2.3 Control Parameters

# Item
8101 MACRO SINGLE
8102 COLL. ALM OFF
8103 COLL. CHK OFF
8105 EDIT LOCK B
8106 G46 NO REV-ERR
(For L system only)
8107 R COMPENSATION
8108 R COMP Select
8109 HOST LINK
2. Machining Parameters
2.3 Control Parameters
Contents
Select the control of the blocks where the user
macro command continues.
0: Do not stop while macro block continues.
1: Stop every block during signal block operation.
Select the interference (bite) control to the
workpiece from the tool diameter during cutter
compensation and nose R offset.
0: An alarm is output and operation stops when
an interference is judged.
1: Changes the path to avoid interference.
Select the interference (bite) control to the work
from the tool diameter during cutter compensation
and nose R offset.
0: Performs interference check
1: Does not perform interference check
Select the edit lock for program Nos. 8000 to 9999.
0: Program can be edited.
1: Editing of above program is prohibited.
Select the control for the compensation direction
reversal in G46 (nose R offset).
0: An alarm is output and operation stops when
the compensation direction is reversed (G41
→ G42‚ G42 → G41).
1: An alarm does not occur when the compensa-
tion direction is reversed‚ and the current
compensation direction is maintained.
0: In arc cutting mode, the machine moves to the
inside because of a delay in servo response to
a command, making the arc smaller than the
command value.
1: In arc cutting mode, the machine compensates
the movement to the inside because of a delay
in servo response to a command
Specify whether to perform arc radius error
correction over all axes or axis by axis.
0: Perform correction over all axes.
1: Perform correction over axis by axis.
(Note) This parameter is effective only when
"#8107 R COMPENSATION" is 1.
Not used.
6
Get other manuals https://www.bkmanuals.com
Setting range (unit)
0/1
0/1
0/1
0/1
0/1
0/1
0/1
0