Mitsubishi Electric MELDAS C6 Parameter Manual page 233

No. Items
3388 SP188 IDGS Spindle
(PR) synchronous
Current loop
gain magnifi-
cation 2
3389 SP189 PG2S Spindle
synchronous
Position loop
gain 2
3390 SP190 PG3S Spindle
synchronous
Position loop
gain 3
3391 SP191
3392 SP192
3393 SP193 SPECT Synchronized
(PR) tapping
specifications
8. Spindle Parameters
8.3 MDS-B-SP/SPH, MDS-C1-SP/SPH
Set the magnification of current loop gain
(excitation component) in the spindle
synchronous mode.
Set the second position loop gain when
high-gain control is carried out in the spindle
synchronous mode.
When this parameter function is not used, set to
"0".
Set the third position loop gain when high-gain
control is carried out in the spindle
synchronous mode.
When this parameter function is not used, set to
"0".
Use not possible.
Not used. Set to "0".
Set the synchronized tapping specifications in
bit units.
F E D
zrtn ptyp od8x
7 6 5
fdir
bit Name Meaning when set to 0 Meaning when set to 1
fclx Closed loop
0
adin Interpolation A/D
1
compensation invalid
rtrn Position monitor during
2
ready OFF invalid
pyfx Normal excitation
3
4 cdir Command polarity (+)
fdir Position detector
5
polarity (+)
6
7
phos Normal
8 (no compensation)
9
A
B
C
od8x Magnification of
D excessive error width ×
8 times invalid
ptyp Position control switch
E type: After zero point
return
zrtn Zero point return
F
direction: CCW
227
Get other manuals https://www.bkmanuals.com
Details
C B A 9 8
phos
4 3 2 1 0
cdir pyfx adin fclx
Semi-closed loop
(Gear 1 : 1 only)
Interpolation A/D
compensation valid
Position monitor during
ready OFF valid
Position loop excitation
fixed (strong)
Command polarity (–)
Position detector
polarity (–)
Synchronized tapping
position compensation
valid
Magnification of
excessive error width ×
8 times valid
Position control switch
type: After deceleration
stop
Zero point return
direction: CW
Setting Standard
range setting
1 to 1000 100
(%)
0 to 999 0
(1/s)
0 to 999 0
(1/s)
0 0
0000 to 0000
FFFF
HEX
setting