Mitsubishi Electric MELDAS C6 Parameter Manual page 44

# Items
1181 G96_ax Constant
surface
speed
control
1182 thr_F Thread
cutting
speed
1183 clmp_M M code for
clamp
1184 clmp_D Dwelling
time after
output-
ting M code
for unclamp
F1 digit
feedrate
1185 spd_F1 F1
1186 spd_F2 F2
1187 spd_F3 F3
1188 spd_F4 F4
1189 spd_F5 F5
1190 s_xcnt Validate
(PR) (For L inclined-axis
control
system
only)
1191 s_angl Inclination
(PR) (For L angle
system
only)
1192 s_zrmv Compensati
(PR) (For L on at
system reference
only) point return
5. Base Specifications Parameters
Details
Specify the axis to be targeted for constant surface
speed control.
0: Program specification will be invalidated‚ and the
axis will always be fixed to the 1st axis.
1: 1st axis specification
2: 2nd axis specification
3: 3rd axis specification
4: 4th axis specification
The program specification will be the priority for all
settings other than 0.
Set the screw cut up speed when not using chamfering
in the thread cutting cycle.
0: Cutting feed clamp feedrate
1 to 60000 mm/min: Set feedrate
Set the M code for C-axis clamp in the hole opening
cycle.
Set the dwell time after outputting the M code for C-axis
unclamp in the hole opening cycle.
Specify the feedrate for the F command in the F1-digit
command ("#1079 F1 digit" is set to 1).
Feedrate when F1 is issued (mm/min)
Feedrate when F2 is issued (mm/min)
Feedrate when F3 is issued (mm/min)
Feedrate when F4 is issued (mm/min)
Feedrate when F5 is issued (mm/min)
0: Disable inclined-axis control
1: Enable inclined-axis control
Specify the inclination angle α of the oblique coordinate
X' axis from the orthogonal coordinate system's X axis.
Specify whether to perform compensation for the base
axis corresponding to the inclined axis at reference
point return.
0: Performs compensation.
1: Does not perform compensation.
38
Get other manuals https://www.bkmanuals.com
Setting range (unit)
0 to 4
0 to 60000
(mm/min)
0 to 99999999
0.000 to 99999.999
(s)
1 to 1000000
(mm/min)
0/1
–80.000 to 80.000
(degree)
0/1