Extron electronics IP Link Pro NBP 50 User Manual page 51

Use This Activation
Mode to...
Temporarily To start the Use Factory Firmware reset mode and replace
boot up the firmware:
unit with
1. On the NBP, press and hold the recessed Reset button
factory-
while applying power to the unit. Keep holding the button
installed
down until the Reset LED blinks twice, then release the
firmware for a
button. The LED blinks slowly during bootup. The unit enters
single power
factory firmware mode.
cycle in the
2. Upload new firmware to the unit as desired (see
event that
the Firmware
a firmware
update has
NOTE: Do not continue to operate the NBP button panel
failed or if
using the factory firmware version. If you want to use
incompatibility
the factory default firmware version, you must upload
issues arise
that version again (see the Toolbelt Help File or Global
with user-
Configurator Help File for firmware upload instructions).
loaded
firmware
Enable or To enable or disable the DHCP client for the LAN port:
disable the
1. Press the Reset button five times (consecutively).
DHCP client
2.
Release the button. Do not press the button within 3 seconds
following the fifth press.
NOTES:
By default DHCP is off and the unit uses a static IP address.
•
When you disable DHCP, the unit reverts to using the previously-set static IP address.
•
Reset IP To reset all IP settings:
settings and
1. Press and hold the Reset button for about 6 seconds until
port maps
the Reset LED blinks twice (once at 3 seconds, again at
to factory
6 seconds).
defaults
2. Release and press the Reset button momentarily (for
without
<1 second) within 1 second*.
affecting
user-loaded * Nothing happens if the momentary press does not occur
files within 1 second.
NOTE: This reset also turns DHCP off.
Start over with To reset the unit to all factory default settings:
configuration
1. Hold down the Reset button for about 9 seconds until the
and uploading
Reset LED blinks three times (once at 3 seconds, again at
6 seconds, again at 9 seconds).
2. Release and press the Reset button momentarily (for
<1 second) within 1 second*.
* Nothing happens if the momentary press does not occur
within 1 second.
NOTES:
•
•
NBP Series Reset Mode Summary
on page 54 for details).
After performing a Reset All IP Settings or Reset to Factory Defaults reset, use
Toolbelt to set the IP address again for use on your network.
The factory configured password for this device has been set to the device serial
number. Passwords are case sensitive. Performing a Reset to Factory Defaults sets
the password to extron.
Result
The button panel reverts to the factory
default firmware. Event scripting does not
start if the unit is powered on in this mode.
All user files and settings such as button
configurations, adjustments, and IP settings
are maintained.
NOTE: To return the unit to the firmware
Updating
version that was running prior to the
reset, cycle power to the unit.
The Reset LED blinks 6 times if the DHCP
•
client is enabled.
The Reset LED blinks 3 times if the DHCP
•
client is disabled.
Reset All IP Settings mode:
Sets the IP address back to factory default
•
(192.168.254.253)
Sets the subnet back to factory default
•
(255.255.255.0)
Sets the default gateway address to the
•
factory default (0.0.0.0)
Sets domain and host names to factory
•
default
Turns DHCP off
•
Disables 802.1X authentication.
•
Reset to Factory Defaults mode performs
a complete reset to factory defaults
(except the firmware).
Does everything Reset All IP Settings mode
•
does
Removes (clears) all user-loaded files and
•
configurations from the NBP
Clears driver-port associations (Ethernet)
•
and port configurations
Network Button Panels • Operation 43