Reset Features And Resetting The Unit; Locating The Reset Button And Led; Resetting The Unit - Extron electronics IP Link Pro NBP 50 User Manual

Reset Features and Resetting the Unit

Locating the Reset Button and LED

The Reset button and LED (shown at right) are
located on the front panel of each decorator-style
or US gang series unit, behind the wallplate
or faceplate (see
or on the bottom panel of the NBP 1200C
(see

Resetting the Unit

There are several reset modes that are available by pressing the Reset button. The Reset
button is recessed, so use an Extron Tweeker, a pointed stylus, or a ballpoint pen to access
it. See the reset modes table on the following page for a summary of the modes.
ATTENTION:
NOTE: If you press and hold the Reset button continuously, the LED blinks every
figure 39, , on page 38)
F
figure 40, , on page 38).
F
Review the reset modes carefully. Using the wrong reset mode may result in
•
unintended loss of flash memory programming, port reassignment, or a unit reboot.
Analysez minutieusement les différents modes de réinitialisation. Appliquer
•
le mauvais mode de réinitialisation peut causer une perte inattendue de la
programmation de la mémoire flash, une reconfiguration des ports ou une
réinitialisation de l'unité.
3 seconds, and the unit enters a different mode, from the Reset All IP Settings mode
through the Reset to Factory Defaults mode. For Reset to Factory Defaults mode
the LED blinks three times, the third blink indicating the last mode. The modes are
separate functions, not a continuation from one mode to the next.
RESET RESET
Decorator-style US Gang
NBP NBP
Network Button Panels • Operation
RESET
NBP 1200C
42