Step 6: Mount The Nbp 1200C To The Table; Insert The Nbp 1200C Enclosure Into The Table; Under The Table, Adjust The Side Clamps On The Enclosure - Extron electronics IP Link Pro NBP 50 User Manual

Step 6: Mount the NBP 1200C to the Table

Insert the NBP 1200C Enclosure Into the Table

1
Remove the plastic plastic
strips and lm on m on
the surface of the f the
Cable Cubby.
2
Ensure that the e
side clamps are e
seated against
the enclosure.
Figure 29. Inserting the NBP 1200C Enclosure into the Table

Under the Table, Adjust the Side Clamps on the Enclosure

Lever
1
Rotate the side clamp
outward and ensure
that the lever is down.
Figure 30.
3
Lower the Cable Cubby
into the hole to test
the t. If necessary,
carefully enlarge
the opening.
1 1
2
Slide the clamp all the
way up against the
bottom of the table.
Securing the Cable Cubby Enclosure
Network Button Panels • Hardware Features and Installation — NBP 1200C
CAUTION: The flanged edges
of the top of the surface
enclosure are sharp. These
edges are also soft and
may be easily nicked or
bent. Exercise caution when
handling the enclosure to
prevent personal injury or
damage to the enclosure.
ATTENTION : Les extrémités
à brides du haut de la surface
du boîtier sont aiguisées.
Ces extrémités sont aussi
lisses et peuvent facilement
être coupées ou pliées.
Soyez prudents lorsque
vous manipulez le boîtier afin
d'éviter de l'endommager ou
de vous blesser.
NOTE: To lower the side clamp, turn the
lever down, then press and hold the
locking plate while sliding down the clamp.
Locking
plate
3
Ensure the Cable Cubby
is rmly seated in the table.
Raise the lever to secure
the Cable Cubby.
31