Extron electronics IP Link Pro NBP 50 User Manual page 46

E
F
G
H
Mounting Holes (x4)
q
ON OFF
LAPTOP
VIDEO
A A A A
RESET
MUTE
NBP 100 Front Panel without Faceplate
Figure 39.
NBP 1200C Bottom Panel
NBP 1200C
Figure 40.
A
Volume LEDs (see figure 36, figure
(present only on models with Volume buttons or a volume knob) light to act as a
meter to indicate the volume level.
Cable Cubby lid (NBP 1200C, see
to 130°. Friction washers ensure the lid holds any angle set by the user. A switch in the
hinge activates the buttons when the lid is fully open and deactivates them when the lid
is closed to prevent accidental button presses.
Button panel removal slots (NBP 1200C, see figure 38) — Use the Extron removal
tool in these slots to release the top of the panel when replacing buttons.
Button panel hinge (NBP 1200C, see figure 38) — Holds the bottom of the panel in
place, allowing the panel to tilt forward when replacing buttons.
MAC Address
PC
ON
A A A A
RESET
NBP 200 Front Panel without Faceplate
NBP Front Panels Without Faceplates or Wallplates
RESET
A
NBP 1200C Bottom Panel Features
Reset button and LED (see figure 39 and figure 40,
recessed button (present on all models) causes various product settings to be reset to
the factory defaults (see Reset Features and Resetting the Unit
LED is normally off except during resets and immediately after boot-up.
37, and figure 38
figure 38 on the previous page) — The lid tilts back
Mounting Holes (x6)
q
PC LAPTOP
OFF
MEDIA
VIDEO
PLAYER
HDMI 1 HDMI 2
MUTE
WIRELESS
00-05-A6-XX-XX-XX
MAC: 00-05-A6-XX-XX-XX
S/N: XXXXXXX EXXXXXX
LAN/PoE
A
Network Button Panels • Operation
on page 37— Volume LEDs
Bezel Tab
Access Holes (2)
Bezel
(Faceplate)
PC
A
LAPTOP
VIDEO
MEDIA PLAYER
HDMI
Mounting
Holes (2)
Wallplate
Attachment
Holes (2)
NBP 105 D
Front Panel
without Wallplate
above)— Pressing this
on page 42). The
38