Eaton Powerware 9390-160/100 Installation And Operation Manual page 130

UPS Operating Instructions
10.1.9 Using the UPS LOAD OFF Pushbutton
A UPS Load Off is initiated by the LOAD OFF pushbutton from the main menu bar or the
System Controls menu bar. This pushbutton can be pressed to control the UPS output. The
UPS LOAD OFF pushbutton de-energizes the critical load and powers down the UPS.
The UPS (including Bypass) remains off until restarted.
To use the LOAD OFF pushbutton:
1. Press the LOAD OFF pushbutton.
All power to the critical load is lost when the LOAD OFF is selected in the following step. You
should use this feature only when you want to de-energize the critical load.
2. To shut down the UPS, press LOAD OFF from the Load Off menu bar, and hold for
Do not attempt to restart the system after Load Off until the cause of the shutdown has been
identified and cleared.
3. To restart the UPS after pressing the LOAD OFF pushbutton, follow the procedure
Power is present inside the UPS cabinet until the upstream input feeder circuit breaker is
opened.
10-6
EATON Powerware
The Load Off screen appears, providing a choice to proceed or abort the
shutdown.
three seconds. To abort the shutdown, press CANCEL.
When LOAD OFF is selected and held for three seconds, the input, output, and
bypass backfeed contactors open, the battery breaker or disconnect is tripped,
and the power module is turned off.
in paragraph 10.1.1 or 10.1.2.
9390 UPS (100–160 kVA) Installation and Operation Manual S 164201554 Rev E powerware.com
®
C A U T I O N
C A U T I O N
W A R N I N G