Operation; Quick Operation Guide - Endress+Hauser PROline prosonic flow 93 Operating Instructions Manual

PROline Prosonic Flow 93 PROFIBUS-DP/-PA
Endress+Hauser
5

Operation

5.1

Quick operation guide

You have a number of options for configuring and commissioning the device:
1. Local display (optional) o Page 56
The local display enables you to read all of the important parameters directly at the
measuring point, configure device-specific parameters in the field and commission the
instrument.
2. Configuration programs o Page 67
The configuration of profile and device-specific parameters is primarily done via the
PROFIBUS-DP/-PA interface. You can obtain special configuration and operating
programs from the various manufacturers for these purposes.
3. Jumpers and miniature switches for hardware settings o Page 78
You can make the following hardware settings for the PROFIBUS-DP/-PA using jumpers
or miniature switches on the I/O board:
x Set the device bus address
x Switch the hardware write protection on/off
Esc
- + E
Fig. 54: Options for operating Prosonic Flow 93 PROFIBUS-DP/-PA
1 Configuration / operation programs for operating the device via the PROFIBUS-DP/-PA
2 Jumpers or miniature switch for hardware settings (write protection, device address)
3 Local display for the operation of the device in the field (optional)
1
Esc
- + E
5 Operation
2
3
Esc Esc
- +
E
55