Nameplate Of The Prosonic Flow U Sensors; Ce Mark, Declaration Of Conformity; Device Certification Profibus-Dp/-Pa - Endress+Hauser PROline prosonic flow 93 Operating Instructions Manual

PROline Prosonic Flow 93 PROFIBUS-DP/-PA
Endress+Hauser
2.1.3

Nameplate of the Prosonic Flow U sensors

ENDRESS+HAUSER
PROSONIC FLOW U
2
U-CL-2F-L-A
Type:
4
TM: -20°C (-4°F) ... +80°C (+175°F)
6 T amb.: -20°C (-4°F) ... +60°C (+140°F)
7 FM
APPROVED
Fig. 3: Nameplate specifications for the "Prosonic Flow U" sensors (example)
1 Ordering code / serial number: See the specifications on the order confirmation for the meanings of the
individual letters and digits.
2 Sensor type
3 Range of nominal diameters: DN 15...100
4 Max. fluid temperature range: -20 °C (-4 °F) ... +80 °C (+175 °F)
5 Degree of protection
6 Ambient temperature range: -20 °C (-4 °F) ... +60 °C (+140 °F)
7 Data on explosion protection
Refer to the specific additional Ex documentation for detailed information. Please do not hesitate to con-
tact your E+H sales office if you have any questions.
2.2

CE mark, declaration of conformity

The devices are designed to meet state-of-the-art safety requirements, have been
tested and left the factory in a condition in which they are safe to operate. The devices
comply with the applicable standards and regulations in accordance with EN 61010
"Protection Measures for Electrical Equipment for Measurement, Control, Regulation
and Laboratory Procedures" and with the EMC requirements of EN 61326/A1.
The measuring system described in these Operating Instructions thus complies with the
statutory requirements of the EC Directives. Endress+Hauser confirms successful
testing of the device by affixing the CE mark.
2.3

Device certification PROFIBUS-DP/-PA

The Prosonic Flow 93 flowmeter has passed all the test procedures implemented and
has been certified and registered by the PNO (PROFIBUS User Organisation). The
flowmeter thus meets all the requirements of the specifications listed below:
x Certified for PROFIBUS Profile 3.0
Device certification number: available upon request
x The instrument meets all of the PROFIBUS Profile 3.0 Specifications.
x The device may also be operated using certified devices from other manufacturers
(interoperability).
1
93UA1-XXXXXXXXXXXX
Order Code:
12345678901
Ser.No.:
3
DN15 - DN100
CL.I, Div.2, GP. ABCD
CL.I, Zone 2 IIC T6-T1
For Installation refer to control dwg. of transmitter
2 Identification
i
CH 1
IP52
5
11