Mouse, External Mouse, And Pc Keyboard; Replacing The Mouse; Replacing The External Mouse; Replacing The Pc Keyboard - Siemens SIREMOBIL Iso-C Troubleshooting Manual

120

Mouse, external mouse, and PC keyboard

NOTE
The system comes with a mouse and an external mouse. Both are connected to the
mouse interface of the 3D reconstruction PC by means of a mouse Y-switch. The key-
board is connected to the keyboard interface of the 3D reconstruction PC.

Replacing the mouse

Switch the system off.
Open the rear panel of the monitor trolley and the cover of the 3D reconstruction PC.
Replace the mouse. Pull the mouse connector out of the mouse Y-switch, cut the cable
ties at the spring steel band, and pull the cable out of the cable duct.
Run the cable of the new mouse through the cable duct and along the spring steel band
and reconnect it.
Reattach the cable from the mouse Y-switch to the keyboard compartment to ensure
that there is sufficient cable length in the keyboard compartment.
Using cable ties, tie the cable (including the keyboard cable) to the spring steel band
again at a distance of approx. 10 cm.
Perform a function check of the mouse, the external mouse, and the keyboard.
Reattach the cover.

Replacing the external mouse

Switch the system off.
Unplug the external mouse at the rear and replace it with the new external mouse.
Perform a function check of the mouse, the external mouse, and the keyboard.

Replacing the PC keyboard

Switch the system off.
Open the rear panel of the monitor trolley and the cover of the 3D reconstruction PC.
Replace the keyboard. Unplug the keyboard at the 3D reconstruction PC, cut the cable
ties at the spring steel band, and pull the cable out of the cable duct.
Run the cable of the new keyboard through the cable duct and along the spring steel
band and reconnect it.
Using cable ties, tie the cable (including the mouse cable) to the spring steel band again
at a distance of approx. 10 cm.
Perform a function check of the mouse, the external mouse, and the keyboard.
Reattach the cover.
SIREMOBIL Iso-C
Replacing boards and components
Only applies to SIREMOBIL Iso-C 3D.
SPR2-230.840.01.01.02
08.08
Page 120 of 148
CS PS SP
6.20
0
0
0
© Siemens, 2008
For internal use only