Siemens SIREMOBIL Iso-C Troubleshooting Manual page 76

76
Function:
Unit serial number
Disable dose rate selection in
user setup
Subtraction K-factor, phase A Noise suppression, phase A, is programmed in the SUB-
Subtraction K-factor, phase B Noise suppression, phase B, is programmed in the
Subtraction Time of phase A The time of phase A in the SUB-mode is programmed.
Roadmap K-factor, phase A
Roadmap K-factor, phase B
Roadmap K-factor, phase C Noise suppression, phase C, is programmed in the roadmap
Roadmap Time of phase A
(1) in menu Diagnostics
SIREMOBIL Iso-C
Comments:
Enter the serial number of the SIREMOBIL Iso-C when it is
equipped with a DICOM bridge. The serial number is
required to identify the images transferred. Please note that
you have to omit the leading 0 when entering the serial num-
ber.
This means "Yes" for SIREMOBIL Iso-C without a dose-area
product measurement device. This means "No" for a SIRE-
MOBIL Iso-C with an dose-area product measurement
device.
mode. Phase A: Mask acquisition.
SUB-mode. Phase B: Acquisition of fill image.
Phase A: Mask acquisition.
Noise suppression, phase A, is programmed in the roadmap
mode. Phase A: Mask acquisition.
Noise suppression, phase B, is programmed in the roadmap
mode. Phase B: Acquisition of fill images.
mode. Phase C: Acquisition of roadmap images.
The time of phase A in the roadmap mode is programmed.
Phase A: Mask acquisition.
SPR2-230.840.01.01.02
08.08
Adjustments / Programs
Page 76 of 148
CS PS SP
© Siemens, 2008
For internal use only